Juniper JNCIP-ENT JN0-649 Question # 9 Topic 1 Discussion

Reviewing POE Interface Information:

The exhibit shows the output of show poe interface and show poe controller commands.

The show poe interface command provides information about the PoE (Power over Ethernet) status on each interface.

Maximum Wattage Allocation:

The show poe controller output indicates that the maximum power available is 100 watts:

plaintext

Copy code

Controller Maximum Power consumption Guard Management Status Lldp

index power band

0 100.00W 22.40W 10W Class AT_MODE Disabled

Thus, statement A is correct.

Power Consumption and Interface Priority:

The interface ge-0/0/11 has a high priority with a max power of 25.4W and current consumption of 11.4W:

plaintext

Copy code

ge-0/0/11 Enabled ON 25.4W(L) High 11.4W 4

Given its high priority, ge-0/0/11 will continue to receive power even if the total power consumption exceeds 90 watts, as high-priority interfaces are less likely to be powered off when resources are low.

POE Status on Interfaces:

The ge-0/0/0 interface is shown as Enabled OFF, indicating PoE is not currently enabled.

plaintext

Copy code

ge-0/0/0 Enabled OFF 15.4W Low 0.0W not-applicable

PoE+ Support:

The ge-0/0/10 interface has a power class of 4, which indicates support for PoE+.

plaintext

Copy code

ge-0/0/10 Enabled ON 25.4W(L) Low 11.0W 4

References:

Exhibit output for show poe interface

Understanding PoE and PoE+ classes and priorities