Pre-Summer Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: validbest

Pass the AEE Energy Management CEM Questions and answers with ValidTests

Exam CEM All Questions
Exam CEM Premium Access

View all detail and faqs for the CEM exam

Viewing page 3 out of 4 pages
Viewing questions 21-30 out of questions
Questions # 21:

In a warehouse, lights are mounted 4 meters above the floor. This provides an average light level of 150 lux. To increase the light level without installing more lights or higher Wattage lights, you lower the light fixtures with pendants so that the lights are located 3.25 meters above the floor. Calculate the new average light level on the floor.

Options:

A.

150 lux

B.

166 lux

C.

176 lux

D.

227 lux

E.

276 lux

Expert Solution
Questions # 22:

Air is heated from 10°C (dry bulb temperature) and 80% relative humidity to 32°C (dry bulb temperature). What is the new relative humidity?

Options:

A.

20%

B.

30%

C.

40%

D.

60%

E.

80%

Expert Solution
Questions # 23:

What is the purpose of monitoring energy consumption?

SELECT THE CORRECT ANSWER

Options:

A.

To establish a basis of management control

B.

To establish when and why there is a deviation in energy consumption patterns

C.

To support analysis of energy information

D.

All of the above

Expert Solution
Questions # 24:

What is the main cause of low power factor?

Options:

A.

Harmonics

B.

Fluorescent lighting

C.

Solar flares

D.

Computers and electronic equipment

E.

Low-load induction motors

Expert Solution
Questions # 25:

An office building is illuminated with T8 fluorescent lamps. Which of the following is the best schedule for group relamping (total replacement of all the T8 fluorescent lamps in the building)?

Options:

A.

When you reach 70% of the rated lamp life

B.

Every 4 years

C.

When 25% of the lamps have failed

D.

When 20% of the ballasts have failed

E.

When the building owner changes

Expert Solution
Questions # 26:

What is the purpose of top (or skimming) blowdown in a steam boiler?

Options:

A.

To reduce the buildup of sediment in the boiler

B.

To reduce the buildup of feedwater chemicals in the boiler

C.

To flush out the boiler room drain system

D.

To dilute the level of impurities in the boiler water thus allowing the addition of cleaner make up water

Expert Solution
Questions # 27:

In general, which of the following is the least expensive and easiest way to finance an energy project?

Options:

A.

Equity

B.

Debt

C.

Performance contract

Expert Solution
Questions # 28:

A compressed air system has a total volume of 247,500 liters. During a 30-minute break in production (air compressor system turned off and no production demand for compressed air), the system pressure drops from 7 bar, gauge (700 kPa, gauge) to 5 bar, gauge (500 kPa, gauge). Calculate the leakage rate in the compressed air system.

Options:

A.

8,250 liters/minute

B.

16,500 liters/minute

C.

22,750 liters/minute

D.

32,000 liters/minute

E.

48,250 liters/minute

Expert Solution
Questions # 29:

At the end of a performance contract, who owns the equipment installed by the project?

Options:

A.

The bank

B.

The energy service company

C.

The equipment manufacturer

D.

The company that paid the contract payments

Expert Solution
Questions # 30:

Which of the following is/are benefits of commissioning?

Options:

A.

Ensures a system is designed to operate as intended

B.

Ensures a system is installed to operate as intended

C.

Ensures staff know how to operate a system as intended

D.

Ensures staff know how to maintain a system as intended

E.

All of the above

Expert Solution
Viewing page 3 out of 4 pages
Viewing questions 21-30 out of questions