Pre-Summer Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: validbest

Discussions
  1. Home
  2. Cisco
  3. CCNP Enterprise
  4. 300-415
  5. Implementing Cisco SD-WAN Solutions (300-415 ENSDWI) Questions and Answers

Pass the Cisco CCNP Enterprise 300-415 Questions and answers with ValidTests

Exam 300-415 All Questions
Exam 300-415 Premium Access

View all detail and faqs for the 300-415 exam

Go to Exam
Viewing page 10 out of 14 pages
Viewing questions 91-100 out of questions
Questions # 91:

Which device in the SD- WAN solution receives and categorizes event reports, and generates alarms?

Options:

A.

WAN Edge routers

B.

vSmart controllers

C.

vManage NMS

D.

vBond controllers

Expert Solution
Questions # 92:

Which platforms are managed by a single vManage dashboard?

Options:

A.

ISR4351, ASR1002HX, vEdge2000, vEdge Cloud

B.

ISR4321, ASR1001, Nexus, ENCS

C.

ISR4321, ASR1001, ENCS, ISRv

D.

ISR4351, ASR1009, vEdge2000, CSR1000v

Expert Solution
Questions # 93:

An engineer is configuring a data policy for IPv4 prefixes for a single WAN Edge device on a site with multiple WAN Edge devices How is this policy added using the policy configuration wizard?

Options:

A.

ln vManage NMS, select the configure ► policies screen, select the localized policy tab and click add policy

B.

In vSmart controller, select the configure ► policies screen, select the localized policy tab. and click add policy

C.

In vManage NMS. select the configure ► policies screen select the centralized policy tab and click add policy

D.

In vBond orchestrator. select the configure ► policies screen, select the localized policy tab. and click add policy

Expert Solution
Questions # 94:

Question # 94

Refer to the exhibit A WAN Edge device was recently added to vManage but a control connection could not be established Which action resolves this issue?

Options:

A.

Rectify the Rod CA certificate mismatch on WAN Edge devices

B.

Install the bootstrap code on WAN Edge and check for CSR

C.

Send the serial number to vBond from the vManage controller.

D.

Resolve the ZTP reachability and rectify smart account credentials issue

Expert Solution
Questions # 95:

Which table is used by the vSmart controller to maintain service routes of the WAN Edge routers in the hub and local branches?

Options:

A.

RIB

B.

FIB

C.

OMP

D.

TLOC

Expert Solution
Questions # 96:

What happens if the intelligent proxy is unreachable in the Cisco SD-WAN network?

Options:

A.

The grey-listed domains are unresolved

B.

The Cisco Umbrella Connector locally resolves the DNS request

C.

The block-listed domains are unresolved

D.

The Cisco Umbrella Connector temporarily redirects HTTPS traffic

Expert Solution
Questions # 97:

What is the default value (in milliseconds) set tor the poll interval in the BFD basic configuration?

Options:

A.

300,000

B.

600,000

C.

900,000

D.

1,200,000

Expert Solution
Questions # 98:

How is the software managed in Cisco SD-WAN?

Options:

A.

Software images must be uploaded to vManage through HTTP or FTP

B.

Software downgrades are unsupported for vManage

C.

Software images must be transferred through VPN 512 or VPN 0 of vManage

D.

Software upgrade operation in the group must include vManage. vBond, and vSmart.

Expert Solution
Questions # 99:

A network administrator is creating an OMP feature template from the vManage GUI to be applied to WAN edge routers. Which configuration attribute will avoid the redistribution of the routes back into the OMP from the LAN side?

Options:

A.

configure "Number of Paths Advertised per Prefix"

B.

configure "Overlay AS Number"

C.

configure "Send Backup Paths"

D.

configure "ECMP limit"

Expert Solution
Questions # 100:

Which feature template configures OMP?

A)

Question # 100

B)

Question # 100

C)

Question # 100

D)

Question # 100

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Expert Solution
Viewing page 10 out of 14 pages
Viewing questions 91-100 out of questions