An administrator is configuring sponsored guest access using Cisco ISE Access must be restricted to the sponsor portal to ensure that only necessary employees can issue sponsored accounts and employees must be classified to do so What must be done to accomplish this task?
Which compliance status is set when a matching posture policy has been defined for that endpomt. but all the mandatory requirements during posture assessment are not met?
What are two components of the posture requirement when configuring Cisco ISE posture? (Choose two)
What are two benefits of TACACS+ versus RADIUS for device administration? (Choose two )
An engineer is designing a new distributed deployment for Cisco ISE in the network and is considering failover options for the admin nodes. There is a need to ensure that an admin node is available for configuration of policies at all times. What is the requirement to enable this feature?
A user changes the status of a device to stolen in the My Devices Portal of Cisco ISE. The device was originally onboarded in the BYOD wireless Portal without a certificate. The device is found later, but the user cannot re-onboard the device because Cisco ISE assigned the device to the Blocklist endpoint identity group. What must the user do in the My Devices Portal to resolve this issue?
An organization is adding new profiling probes to the system to improve profiling on Oseo ISE The probes must support a common network management protocol to receive information about the endpoints and the ports to which they are connected What must be configured on the network device to accomplish this goal?
An administrator is configuring a switch port for use with 802 1X What must be done so that the port will allow voice and multiple data endpoints?
An engineer needs to configure a Cisco ISE server to issue a CoA for endpoints already authenticated to access the network. The CoA option must be enforced on a session, even if there are multiple active sessions on a port. What must be configured to accomplish this task?
Refer to the exhibit. An engineer must configure BYOD in Cisco ISE. A single SSID must be used to allow BYOD devices to connect to the network. These configurations have been performed on Wireless LAN Controller already:
RADIUS server
BYOD-Dot1x SSID
Which two configurations must be done in Cisco ISE to meet the requirement? (Choose two.)
