The configuration snippet shows that MPLS and LDP are configured globally but not enabled on an interface. The commands include “mpls label protocol ldp,” “mpls ldp router-id loopback 0,” and “mpls ip,” which are necessary for global settings. However, to establish LDP neighbors and exchange labels, LDP must be enabled on the specific interface where it’s needed.
References:
Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR)
Cisco SPCOR Training resources available on the Cisco Learning Network Store.
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit