Pre-Summer Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: validbest

Pass the HP Aruba Certified Switching Associate (ACSA) V1 HPE6-A72 Questions and answers with ValidTests

Exam HPE6-A72 All Questions
Exam HPE6-A72 Premium Access

View all detail and faqs for the HPE6-A72 exam

Viewing page 3 out of 4 pages
Viewing questions 21-30 out of questions
Questions # 21:

Match each network protocol to the current default listening port and transport protocol. Not all answer will be used.

Question # 21

Options:

Expert Solution
Questions # 22:

Refer to the exhibit.

Question # 22

What does the command page result in?

Options:

A.

Starts an automatic page scrolling effect that pauses for a few seconds every 30 rows.

B.

Enables a terminal notification when a new debug event occurs for L2MAC events.

C.

Shows a new terminal window opening to allow typing while debugging occurs.

D.

Results in a page break to disable the default continuous scrolling In the console.

Expert Solution
Questions # 23:

Which switches support Aruba Virtual Switching Extension (VSX)? (Choose two.)

Options:

A.

Aruba 6405

B.

Aruba 2930F

C.

Aruba 8400

D.

Aruba 5406R

E.

Aruba 8350

Expert Solution
Questions # 24:

You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch.

What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

Options:

A.

checkpoint rollback 10

B.

checkpoint auto 10

C.

checkpoint auto confirm 10

D.

boot system secondary 10

Expert Solution
Questions # 25:

What is the binary conversion of the hexadecimal value 0x2001?

Options:

A.

0010 0001

B.

0002 0000 0000 0001

C.

0011 0000 0000 0001

D.

0010 0000 0000 0001

Expert Solution
Questions # 26:

What are the benefits of a 3-Tier design over a 2-Tier? (Choose two.)

Options:

A.

Offloading processing from the Core without routing at the Access layer.

B.

Can use lower speed links between Core to Aggregation and Aggregation to Access given the use of an Aggregation layer.

C.

Lowering the cost of a deployment due to needing less switches overall.

D.

Better scalability in a campus with a large number of buildings.

E.

Gaining the flexibility to connect the Data-Center to any Access layer switch.

Expert Solution
Questions # 27:

Refer to the exhibit.

Question # 27

Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN.

Which configuration will correct the issue?

Options:

A.

Core-2(config)# ip route 0.0.0.0/0 10.1.1.1 vrf GREEN Host-B: assign the default-gateway address 10.1.20.181

B.

Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN Host-B: assign the default-gateway address 10.1.20.181

C.

Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN Host-B: assign the default-gateway address 10.1.20.1

D.

Host-B: assign the default-gateway address 10.1.20.181

Expert Solution
Questions # 28:

Which statement is true regarding modern switching requirements?

Options:

A.

Most older legacy switches had high port bandwidth utilization and were future proof designed to meet today's power-over-Ethernet needs.

B.

Requirements for PoE are normally addressed using AC to DC power adapters. Concerns for port security for IoT devices are usually addressed using default wired encryption that all 802.3 Ethernet switches provide.

C.

While APs are common, most clients are still docked and only require traditional wired connections with only the occasional dedicated PoE switch to provide power for the low number of devices needed.

D.

Clients tend to prefer wireless connections, raising the need for PoE port access. There is also a growing amount of IoT devices that require security and port authentication options.

Expert Solution
Questions # 29:

What are two features in a 2-Tier design that are implemented at the Access layer? (Choose two.)

Options:

A.

VPN access

B.

WAN/MPLS connectivity

C.

Endpoint Access

D.

Deep packet inspection

E.

Power over Ethernet

Expert Solution
Questions # 30:

Refer to the exhibit.

Question # 30

Question # 30

Refer to the diagram where all switches are CX 6300Ms. Which MSTP configuration should be applied to Core-2 in order for Core-2 to join the domain as the primary for Instance 2 and secondary for Instance 1?

Options:

A.

A close-up of words Description automatically generated

B.

A black text on a white background Description automatically generated

C.

A black text on a white background Description automatically generated

D.

A black text on a white background Description automatically generated

Expert Solution
Viewing page 3 out of 4 pages
Viewing questions 21-30 out of questions