Pass the Cisco CCNP Data Center 300-615 Questions and answers with ValidTests

Exam 300-615 Premium Access

View all detail and faqs for the 300-615 exam

Go to Exam

Viewing page 3 out of 7 pages

Viewing questions 21-30 out of questions

Questions # 21:

Refer to the exhibit.

Question # 21

The scheduler job fails to run. Which action resolves the issue?

Options:

Change the file name.

Configure the authentication credentials.

Change the TFTP server address.

Configure the RBAC authentication.

Expert Solution

Questions # 22:

An engineer configures FCoE between a set of ESXi hosts and a Cisco Nexus 5000 Series Switch. The Converged Network Adapter of the host fails to receive the response from the Cisco Nexus device. Also, the VFC interface is in a down state and the FIP adapter fails to receive 802.1q tagged frames. The host interface is configured for VLAN trunking. Which action resolves the issue?

Options:

Activate the reception of Xoff pause frames from the server

Configure the UF link as a spanning-tree edge port

Enable the active STP port state on the bound Ethernet interface

Set the bound Ethernet trunk interface to non-FCoE native VLAN

Expert Solution

Questions # 23:

Refer to the exhibit.

Question # 23

The scheduler was configured to save the running-config automatically daily. However, the scheduler is returning the error presented. Which action resolves the issue?

Options:

Reconfigure the scheduler using the admin user

Use the kstack attribute for copying the configuration file

Remove vrf management from the command

Change the file transfer protocol to TFTP in scheduler job

Expert Solution

Questions # 24:

A system administrator connects a Cisco Nexus 2248PQ FEX to a fabric interconnect to expand the ports that

are available for connecting Cisco UCS C-Series Rack Servers. In Cisco UCS Manager, the administrator does

not see the servers connected to this FEX. Which action should be taken to resolve the issue?

Options:

The FEX must be exchanged so that it supports the connectivity between fabric interconnects and UCS CSeries

servers

The fabric interconnects must be rebooted before the FEX is recognized

The transceivers must be exchanged to support the connectivity between the FEX and the fabric

interconnects

The ports that connect the FEX to the fabric interconnects must be configured as server ports

Expert Solution

Questions # 25:

An engineer must configure Linux hosts that are deployed on Cisco UCS B-Series Servers to boot from SAN. The SAN boot policy is configured in Cisco UCS Manager, and the boot order is verified to be set as expected However, the Linux hosts fail to boot. Which action resolves the issue?

Options:

Remove all of the local storage that is installed

Delete and reconfigure the pWWN of the SAN boot target

Remove all of the ISO images that are mounted as a virtual CD-ROM

Delete and reconfigure the boot LUN

Expert Solution

Questions # 26:

Refer to the exhibit.

Question # 26

The vPC between switch1 and switch2 does not work. Which two actions resolve the problem? (Choose two.)

Options:

Configure the IP address on the interface.

Activate VLANs on the vPC.

Configure one of the switches as primary for the vPC.

Correct the configuration of the vPC peer link and the vPC peer keepalive.

Match the vPC domain ID between the two devices.

Expert Solution

Questions # 27:

Refer to the exhibit.

Question # 27

An engineer fails to implement a Cisco UCS Manager integration manager. The credentials and IP connectivity between Cisco APIC and UCS Manager are configured as expected. Which action resolves the issue?

Options:

Disable HTTP to HTTPS redirection in Cisco UCS Manager

Enable JSON API on the Cisco UCS Manager

Change the Integration Manager name to FQDN of the Cisco UCS Manager

Install ExternalSwitch app in the APIC controller

Expert Solution

Questions # 28:

An engineer attempts to register Cisco UCS Manager to Cisco UCS Central, but the registration fails. The engineer can ping Cisco UCS Central from UCS Manager. Which two actions must the engineer attempt to resolve the problem? (Choose two.)

Options:

Synchronize the date and time to NTP for Cisco UCS Central and the Cisco UCS domains.

Apply the UCS Central license to UCS Central.

Place Cisco UCS Manager on the same subnet as Cisco UCS Central.

Allow port 443 between Cisco UCS Manager and Cisco UCS Central.

Allow port 9443 between Cisco UCS Manager and Cisco UCS Central.

Expert Solution

Questions # 29:

Cisco Unified Computing System Manager raises a critical error message that indicates that the system has overlapping Ethernet and FCoE VLANs. All of the Ethernet traffic on the overlapping VLANs drops. Which action resolves the issue?

Options:

Modify the VLAN assignment to vNICs.

Change the PIN groups on the vHBAs.

Modify the FCoE VLAN.

Set the FCoE VLAN as the native VLAN on server uplinks.

Expert Solution

Questions # 30:

Refer to the exhibits.

Question # 30

An engineer troubleshoots switch N5K1, which fails to receive traffic from the file server Which set of actions resolves this problem?

Options:

Bind native VLAN 10 with Ethemet1/10 and allow VSAN 101 in trunk configuration.

Assign native VLAN 10 with vfc111 and allow VLAN 1101 in trunk configuration.

Bind native VLAN 10 with Ethemet10/1/1 and allow VLAN 10 in trunk configuration

Assign native VLAN 10 with fc2.'l - 2 and allow VLAN 10 in trunk configuration.

Expert Solution

Viewing page 3 out of 7 pages

Viewing questions 21-30 out of questions

Pre-Summer Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: validbest

Pass the Cisco CCNP Data Center 300-615 Questions and answers with ValidTests

Exam 300-615 Premium Access

Options:

Options:

Options:

Options:

Options:

Options:

Options:

Options:

Options:

Options: