Pre-Summer Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: validbest

Pass the Cisco CCNP Collaboration 350-801 Questions and answers with ValidTests

Exam 350-801 All Questions
Exam 350-801 Premium Access

View all detail and faqs for the 350-801 exam

Viewing page 4 out of 13 pages
Viewing questions 31-40 out of questions
Questions # 31:

How many minutes does it take for automatic fallback to occur in a Presence Redundancy Group if the primary node lost a critical service?

Options:

A.

5 min

B.

10 min

C.

30 min

D.

60 min

Expert Solution
Questions # 32:

An engineer is configuring IP telephony. The network relies on DHCP to provide TFTP server addresses to the endpoints. Policy requires the endpoints to receive two server addresses. Which DHCP option must be configured?

Options:

A.

66

B.

143

C.

150

D.

166

Expert Solution
Questions # 33:

A collaboration engineer is configuring the QoS trust boundary for Cisco UCM voice and video conferencing. Which two trust boundary configurations are valid? (choose two)

Options:

A.

QoS trust boundaries include all the devices directly attached to the access switch ports

B.

QoS trust boundaries can be extended to Jabber running on a PC

C.

QoS trust boundaries exclude Jabber softphone running on a PC

D.

QoS trust boundaries can be extended to voice and video devices if the connected PCs are included

E.

QoS trust boundaries can be extended to voice and video devices exclusively

Expert Solution
Questions # 34:

How are network devices monitored in a collaboration network?

Options:

A.

The Cisco Discovery Protocol table is shared among devices.

B.

Ping Sweep reports "unmanaged' state devices.

C.

System logs are collected in a Cisco Prime Collaboration Server.

D.

Simple Network Managed Protocol is enabled on each device to poll specific values periodically.

Expert Solution
Questions # 35:

A Cisco UCM administrator sets up new route patterns to support phones in tour different locations, all with local gateways. The administrator wants to use the same route pattern for all four locations. How must the system be configured to achieve this goal?

Options:

A.

Use CSS alternate routing rules.

B.

Use standard local route groups.

C.

Add a CSS to each local gateway.

D.

Use transforms in the route groups.

Expert Solution
Questions # 36:

Why is an end user’s PC device not included in a QoS trust boundary?

Options:

A.

The end user could incorrectly tag their traffic to advertise their PC as a default gateway.

B.

The end user may Incorrectly tag their traffic k> be prioritized over other network traffic.

C.

The end user could incorrectly tag their traffic to bypass firewalls.

D.

There is no reason not to include an end user's PC device in a QoS trust boundary.

Expert Solution
Questions # 37:

Which actions required for a firewall configuration on a Mobile and Remote Access

through Cisco Expressway deployment?

Options:

A.

The traversal zone on Expressway-c points to Expressway-e through the peer address field on the traversal zone, which specifies the Expressway-e server address. For dual NIC deployments, set the Expressway-e address using an FQDN that resolves the IP address of the internal interface

B.

The external firewall must allow these inbound connections to Expressway: SIP: TCP 5061; HTTPS: TCP 8443; XMPP TCP 5222; media: UDP 36002 to 59999

C.

Do not use a shared address for Expressway-e and Expressway-c, as the firewall

cannot distinguish between them. If static NAT for IP addressing on Expressway-e is used, ensure that any NAT operation on expressway-c does not resolve the same traffic IP address. Shared NAT IS not supported

D.

The internal firewall must allow these inbound and outbound connections between

expressway - c and Expressway-e :sip;HTTPS(tunneled over SSH between C and E.

TCP 2222: TCP 7001: Traversal Media: UDP 2776 to 2777(or 36000 to 36011 for large VM/appliance); XMPP:TCP 7400

Expert Solution
Questions # 38:

Endpoint A is attempting to call endpoint B. Endpoint A only supports G.711ulaw with a packetization rate of 20 ms, and endpoint B supports packetization rate of 30 ms for G.711ulaw. Which two media resources are allocated to normalize packetization rates through transrating? (Choose two.)

Options:

A.

software MTP on Cisco IOS Software

B.

software MTP on Cisco UCM

C.

software transcoder on Cisco UCM

D.

hardware transcoder on Cisco IOS Software

E.

hardware MTP on Cisco IOS Software

Expert Solution
Questions # 39:

An administrator is trying to change the default LINECODE for a voice ISDN T1 PRI. Which command makes this change?

Options:

A.

linecode ami

B.

linecode b8zs

C.

linecode hdb3

D.

linecode esf

Expert Solution
Questions # 40:

Which characterstic of distributed class- based weighted fair queueing addresses jitter

prevention?

Options:

A.

It provides additional granularity by allowing a user to create classes

B.

It minimizes jitter by implementing a priority queue for voice traffic

C.

It uses a priority queue for voice traffic to avoid jitter.

D.

It provides additional granularity by allowing a user to define custom class

Expert Solution
Viewing page 4 out of 13 pages
Viewing questions 31-40 out of questions