Which command is used to check IP SLA when an interface is suspected to receive lots of traffic with options?
An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)
What is the output of the following command:
show ip vrf
Which configuration enabled the VRF that is labeled “Inet” on FastEthernet0/0?
Refer to the exhibit.
The output of the trace route from R5 shows a loop in the network. Which configuration
prevents this loop?
A)
B)
C)
D)
Which two protocols can cause TCP starvation? (Choose two)
Refer to the exhibit.
An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries. Which action ensures consistency between the two times?
Which is statement about IPv6 inspection is true?
Which protocol does MPLS use to support traffic engineering?
Refer to the exhibit.
An engineer is trying to redistribute OSPF to BGP, but not all of the routes are
redistributed. What is the reason for this issue?
Refer to the exhibit.
AAA server 10.1.1.1 is configured with the default authentication and accounting settings, but the switch cannot communicate with the server Which action resolves this issue?
Users were moved from the local DHCP server to the remote corporate DHCP server. After the move,
none of the users were able to use the network.
Which two issues will prevent this setup from working properly? (Choose two)
Refer to the exhibit.
An engineer configures a static route on a router, but when the engineer checks the route
to the destination, a different next hop is chosen. What is the reason for this?
Refer to the exhibit.
ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links to
achieve redundancy and cannot see the Cisco IOS IP SLA tracking output on the router console. Which command is missing from the IP SLA configuration?
Which security feature can protect DMVPN tunnels?
