While troubleshooting connectivity issues to a router, these details are noticed:
Standard pings to all router interfaces, including loopbacks, are successful.
Data traffic is unaffected.
SNMP connectivity is intermittent.
SSH is either slow or disconnects frequently.
Which command must be configured first to troubleshoot this issue?
Which is statement about IPv6 inspection is true?
Refer to the exhibit. An engineer has successfully set up a floating static route from the BRANCH router to the HQ network using HQ_R1 as the primary default gateway When the g0/0 goes down on HQ_R1, the branch network cannot reach the HQ network 192.168.20.0/24. Which set of configurations resolves the issue?
Refer to the exhibit.
An engineer must configure a LAN-to-LAN IPsec VPN between R1 and the remote router. Which IPsec
Phase 1 configuration must the engineer use for the local router?
Refer to the exhibit.
ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links to
achieve redundancy and cannot see the Cisco IOS IP SLA tracking output on the router console. Which command is missing from the IP SLA configuration?
Which IPv6 feature enables a device to reject traffic when it is originated from an address that is not stored in the device binding table?
Refer to the exhibit R2 has been receiving routes from R4 that originated outside AS300 A network engineer configured an AS-Path ACL to avoid adding these routes to the R2 BGP table but the routes are still present in the R2 routing table Which action resolves the issue?
During the maintenance window an administrator accidentally deleted the Telnet-related
configuration that permits a Telnet connection from the inside network (Eth0/0) to the outside of the networking between Friday – Sunday night hours only. Which configuration resolves the issue?
A)
B)
C)
D)
Refer to the exhibit.
An engineer is trying to block the route to 192.168.2.2 from the routing table by using the
configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?
Refer to the exhibit.
Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64?
A)
B)
C)
D)
Refer to the exhibit. Users are experiencing slow response times from critical application servers connected to the network. The engineer determined from the console log that there is a DOS attack on the interface GigabitEthernet0/0. Which action must the engineer take to resolve the issue?
Refer to the exhibit.
An engineer must configure EIGRP between R1 and R2 with no summary route. Which configuration resolves the issue?
A)
B)
C)
D)
What are the two reasons for RD and VPNv4 addresses in an MPLS Layer 3 VPN? (Choose two.)
Which label operations are performed by a label edge router?
Refer to the exhibit.
Which statement about R1 is true?
