Summer Certification Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: validbest

Pass the Cisco CCNP Collaboration 300-815 Questions and answers with ValidTests

Exam 300-815 All Questions
Exam 300-815 Premium Access

View all detail and faqs for the 300-815 exam

Viewing page 5 out of 8 pages
Viewing questions 41-50 out of questions
Questions # 41:

Refer to the exhibit.

Question # 41

While troubleshooting call failures on the Cisco Unified Border Element, an administrator notices that messages are being sent to the service provider, but there is no response The administrator later learns that this SIP provider does not support PRACK. Which header should be removed from the SIP message to resolve this issue?

Options:

A.

Content-Disposition: session:handling=required

B.

Require 100rel

C.

Contact

D.

Content-Type: application/sdp

Expert Solution
Questions # 42:

For s SIP to SIP call flow, when does Cisco Unified Border Element require transcoding resources for DTMF?

Options:

A.

interworking between an OOB method and RFC2833 for flow-around calls

B.

interworking between h245-signal and rtp-nte

C.

interworking between an OOB method and RFC2833 for flow-through calls

D.

interworking between h245-alpha numeric and sip-kpml

Expert Solution
Questions # 43:

Refer to the exhibit.

Question # 43

A call mode through the Cisco Unified Border Element to pilot 2000 is foiling. What is causing the call to foil?

Options:

A.

No codecs are configured on the dial peers

B.

The Cisco Unified Border Element is not receiving a response to its OPTION keepahves.

C.

The destination pattern is incorrect for the dialed number.

D.

VAD was not disabled on the outgoing dial poor.

Expert Solution
Questions # 44:

What are the elements for Device Mobility configuration?

Options:

A.

physical location, device pool, and Device Mobility group

B.

device pool, Device Mobility group, and region

C.

physical location. Device Mobility group, and region

D.

device pool, Device Mobility group, and Cisco IP phone

Expert Solution
Questions # 45:

Refer to the exhibit.

Question # 45

A collaboration engineer is troubleshooting an issue where the PSTN calls of a Cisco UCM IP phone user are not reaching the PSTN gateway. Which action resolves the issue?

Options:

A.

Deselect "Block this pattern" on the route pattern.

B.

Change the calling search space of The user's line or device.

C.

Change the "Call Classification" to "OnNet" on the route pattern.

D.

Ensure that the user's phone is assigned to a device pool with the correct local route group settings.

Expert Solution
Questions # 46:

What are two functions of the metadata in SIP recording? (Choose two.)

Options:

A.

includes the details of the application media stream

B.

contains the cryptographic context of the SRTP passthrough calls

C.

identifies the session and media association time

D.

carries the Agent Statistics Report

E.

carries the communication session data (audio and video calls) that describes the call to the recording server

Expert Solution
Questions # 47:

Question # 47

Refer to the exhibit. An administrator configured Device Mobility but is receiving reports that local calls are failing when a user takes their device from the RTP location to the Charlotte location. The administrator confirmed that the correct subnet is configured under the Device Mobility info page. In addition, the roaming device pool has the correct Device Mobility calling search space selected. Which configuration change resolves the issue?

Options:

A.

Join across lines is not supported with Device Mobility and must be disabled.

B.

The network locale must be changed from none to the Charlotte locale.

C.

The physical location must be updated from none to the appropriate location.

D.

The device must be added to the Device Mobility group.

Expert Solution
Questions # 48:

An engineer must configure a secure SIP trunk with a remote provider, with a specific requirement to use port

5065 for inbound and otubound traffic. Which two items must be configured to complete this configuration? (Choose two.)

Options:

A.

Incoming Port in SIP Information section of the SIP Trunk configuration.

B.

Incoming Port in Security Information of the SIP Profile configuration.

C.

Destination Port in SIP Information section of the SIP Trunk configuration

D.

Incoming Port in SIP Trunk Security Profile configuration

E.

Destination Port in SIP Trunk Security Profile configuration

Expert Solution
Questions # 49:

An administrator troubleshoots call failure in a new deployment and finds that the SIP INVITE messages sent to the service provider contain a diversion header with the user's 4-digit directory number. These 4-digit directory numbers range from 1000 to 9999. The service provider is rejecting the calls because it requires that the diversion header contain 10 digits. Which command on the Cisco Unified Border Element resolves this issue for all users?

A)

Question # 49

B)

Question # 49

C)

Question # 49

D)

Question # 49

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Expert Solution
Questions # 50:

An IP Telephony administrator is deploying IP phones The administrator has an existing Cisco UCME router with several SCCP & SIP phones registered. The administrator receives a request for a new SIP phone with MAC address 1111 2222.3333 and directory number 2050 to be added in the Cisco UCME. Which two configurations should be added in CME to support this request? (Choose two )

Question # 50

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

E.

Option E

Expert Solution
Viewing page 5 out of 8 pages
Viewing questions 41-50 out of questions