An engineer needs to configure a translation pattern in Cisco UCM to match dialed numbers that start with 9011 so that the calls can be routed with a single route pattern of VH If the engineer uses translation pattern 9011.! which two called party transformation settings must be configured in Cisco UCM? (Choose two.)
Refer to the exhibit.
Which INVITE is sent to 10.10.100.123 as a result of this log?
A)
B)
C)
D)
Which IOS command creates a SIP-enabled dial peer?
Configure Call Queuing in Cisco Unified Communications Manager. Where do you set the maximum number of callers in the queue?
Refer to the exhibit.
The customer is troubleshooting an issue where users cannot dial the CMS SIP Route Pattern. The CMS URI they are attempting to dial is 7772002@cms.domain.local. Which IPv4 pattern must the customer enter to resolve the issue?
A solution for a large company is being reconfigured to optimize for cost saving. The company has an extensive global QoS-enabled network with enough bandwidth to create a converged network. Local calls are relatively inexpensive in countries the company have operations, but long distance and international calls are expensive.
Which type of configuration supported by Cisco UCM would help optimize cost control for this company?
Users in a small location report that audio calls work Tine, but only one video call works before the next one gets a busy signal. Three video conference rooms were recently installed by a third party. The audio and video devices are Cisco endpoints. The site uses video and audio calls, and a network investigation does not show saturation on the link The site is configured with QoS and CoS. All devices are registered on the headquarters Cisco UCM duster. What is the cause of this problem?
When route patterns are defined as precisely as possible on a Cisco UCM, the control and reliability of the calling plan is increased. A route pattern must be added to support calls to this number range: 9135200 to 9135205. The calls are on-net and no translation patterns are configured. Which configuration meets these requirements?
What are two configureation features of the Client matter code setting in the route pattern configuration? (Choose two.)
A company has users that are logged in to hunt groups. However, there is a requirement for hunt group configurations to provide an option to turn on audible ringtones when calls to a line group arrive at a phone that is logged out and on a break. This ringtone alerts a logged-out user that there is an incoming call to a hunt list to which the line is a member, but the call does not ring at the phone of that line group member because of the logged-out status. Which action meets this requirement?
