An engineer must configure a core router with a floating static default route to the backup router at 10.200.0.2.
Which technology can prevent client devices from arbitrarily connecting to the network without state remediation?
How does WPA3 improve security?
Which statement correctly compares traditional networks and controller-based networks?
What are two characteristics of a controller-based network? (Choose two)
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN Controller is true?
Refer to the exhibit.
All VLANs are present in the VLAN database. Which command sequence must be applied to complete the configuration?
An engineer must configure traffic for a VLAN that is untagged by the switch as it crosses a trunk link. Which command should be used?
An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any of three addresses 192.168.30.1, 192.168.3.2, 192.168.3.3 Which configuration should be used?
With REST API, which standard HTTP header tells a server which media type is expected by the client?
Refer to the exhibit.
Between which zones do wireless users expect to experience intermittent connectivity?
Refer to the exhibit.
An administrator is tasked with configuring a voice VLAN. What is the expected outcome when a Cisco phone is connected to the GigabitEfriemet3/1/4 port on a switch?
What is the primary different between AAA authentication and authorization?
What is the same for both copper and fiber interfaces when using SFP modules?
Refer to the exhibit.
Which configuration allows routers R14 and R86 to form an OSPFv2 adjacency while acting as a central point for exchanging OSPF information between routers?
A)
B)
C)
D)
Which two spanning-tree states are bypassed on an interface running PortFast? (Choose two.)
Refer to the exhibit.
Switch A is newly configured. All VLANs are present in the VLAN database. The IP phone and PC A on Gi0/1 must be configured for the appropriate VLANs to establish connectivity between the PCs. Which command set fulfills the requirement?
A)
B)
C)
D)
Refer to the exhibit.
Which switch becomes the root of a spanning tree for VLAN 20 if all li links are of equal speed?
Which value is the unique identifier that an access point uses to establish and maintain wireless connectivity to wireless network devices?
Refer to the exhibit.
The following must be considered:
• SW1 is fully configured for all traffic
• The SW4 and SW9 links to SW1 have been configured
• The SW4 interface Gi0/1 and Gi0/0 on SW9 have been configured
• The remaining switches have had all VLANs adde d to their VLAN database
Which configuration establishes a successful ping from PC2 to PC7 without interruption to traffic flow between other PCs?
A)
B)
C)
D)
Which WLC management connection type is vulnerable to man-in-the-middle attacks?
Refer to the exhibit.
Which configuration enables DHCP addressing for hosts connected to interface FastEthernetO/1 on router R4?
Refer to the exhibit.
The router has been configured with a supernet to accommodate the requirement for 380 users on a subnet The requirement already considers 30% future growth. Which configuration verifies the IP subnet on router R4?
A)
B)
C)
D)
Which QoS traffic handling technique retains excess packets in a queue and reschedules these packets for later transmission when the configured maximum bandwidth has been surpassed?
Refer to the exhibit.
An engineer is asked to insert the new VLAN into the existing trunk without modifying anything previously configured Which command accomplishes this task?
A network engineer must implement an IPv6 configuration on the vlan 2000 interface to create a routable locally-unique unicast address that is blocked from being advertised to the internet. Which configuration must the engineer apply?
Refer to the exhibit.
Web traffic is coming in from the WAN interface. Which route takes precedence when the router is processing traffic destined for the LAN network at 10 0.10.0/24?
Which interface mode must be configured to connect the lightweight APs in a centralized architecture?
Refer to the exhibit.
An engineer assumes a configuration task from a peer Router A must establish an OSPF neighbor relationship with neighbor 172 1 1 1 The output displays the status of the adjacency after 2 hours. What is the next step in the configuration process for the routers to establish an adjacency?
Refer to the exhibit.
Packets received by the router from BGP enter via a serial interface at 209.165.201.10. Each route is present within the routing table. Which interface is used to forward traffic with a destination IP of 10.10.10.24?
Which field within the access-request packet is encrypted by RADIUS?
Refer to the exhibit.
Which two commands must be configured on router R1 to enable the router to accept secure remote-access connections? (Choose two)
Refer to the exhibit.
What is a reason for poor performance on the network interface?
What differentiates device management enabled by Cisco DNA Center from traditional campus device management?
Refer to the exhibit An IPv6 address must be obtained automatically on the LAN interface on R1 Which command must be implemented to accomplish the task?
Company has decided to require multifactor authentication for all systems. Which set of parameters meets the requirement?
What are two reasons to implement DHCP in a network? (Choose two.)
Refer to the exhibit.
What must be configured to enable 802.11w on the WLAN?
What are two benefits of FHRPs? (Choose two.)
Which two server types support dornas name to IP address resolution? (Choose two >
Refer to the exhibit.
The link between PC1 and the switch is up. but it is performing poorly. Which interface condition is causing the performance problem?
Drag and drop the TCP or UDP details from the left onto their corresponding protocols on the right.
Which QoS per-hop behavior changes the value of the ToS field in the IPv4 packet header?
Drag and drop the characteristic from the left onto the IPv6 address type on the right.
What does WPA3 provide in wireless networking?
Refer to the exhibit.
The DHCP server and clients are connected to the same switch. What is the next step to complete the DHCP configuration to allow clients on VLAN 1 to receive addresses from the DHCP server?
Refer to the exhibit.
PC A is communicating with another device at IP address 10.227.225.255. Through which router does router Y route the traffic?
Refer to the exhibit.
How must OSPF be configured on the GigabitEthernet0/0 interface of the neighbor device to achieve.
A)
B)
C)
D)
An engineer is tasked to configure a switch with port security to ensure devices that forward unicasts multicasts and broadcasts are unable to flood the port The port must be configured to permit only two random MAC addresses at a time Drag and drop the required configuration commands from the left onto the sequence on the right Not all commands are used.
Refer to the exhibit.
Which two configurations must the engineer apply on this network so that R1 becomes the DR? (Choose two.)
A)
B)
C)
D)
E)
