Refer to the exhibit.
Which command must be executed for Gi1.1 on SW1 to become a trunk port if Gi1/1 on SW2 is configured in desirable or trunk mode?
Refer to the exhibit.
An engineer configured the New York router with state routes that point to the Atlanta and Washington sites. When command must be configured on the Atlanta and Washington routers so that both sites are able to reach the loopback2 interface on the New York router?
When a client and server are not on the same physical network, which device is used to forward requests and replies between client and server for DHCP?
What are two recommendations for protecting network ports from being exploited when located in an office space outside of an IT closer? (Choose two.)
Refer to Exhibit.
Which configuration must be applied to the router that configures PAT to translate all addresses in VLAN 200 while allowing devices on VLAN 100 to use their own IP addresses?
Refer to Exhibit.
An engineer is configuring the NEW York router to reach the Lo1 interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two)
Refer to the exhibit.
What is the effect of this configuration?
What makes Cisco DNA Center different from traditional network management applications and their management of networks?
Refer to the exhibit.
The nip server 192.168.0.3 command has been configured on router 1 to make it an NTP client of router 2. Which command must be configured on router 2 so that it operates in server-only mode and relies only on its internal clock?
Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?
Which technology can prevent client devices from arbitrarily connecting to the network without state remediation?
Refer to the exhibit.
Which prefix does Router 1 use for traffic to Host A?
Refer to the exhibit.
An engineer must configure the interface that connects to PC 1 and secure it in a way that only PC1 is allowed to use the port No VLAN tagging can be used except for a voice VLAN. Which command sequence must be entered to configure the switch?
A)
B)
C)
D)
How does network automation help reduce network downtime?
Refer to the exhibit.
A new VLAN and switch are added to the network. A remote engineer configures OldSwitch and must ensure that the configuration meets these requirements:
• accommodates current configured VLANs
• expands the range to include VLAN 20
• allows for IEEE standard support for virtual LANs
Which configuration on the NewSwitch side of the link meets these requirements?
A)
B)
C)
D)
Which part of the HTTP request is used in REST API basic authentication to carry credentials?
Drag and drop the elements of a security program from the left onto the corresponding descriptions on the right.
Drag and drop the characteristic from the left onto the IPv6 address type on the right.
Refer to the exhibit. An engineer must translate the PC1 IP address to 10.199.77.100 and permit PC1 to ping the loopback 0 on router R2. What command set must be used?
A)
B)
C)
D)
Refer to the exhibit.
A network engineer must configure router R1 with a host route to the server. Which command must the engineer configure?
Which interface or port on the WLC is the default for in-band device administration and communications between the controller and access points?
Which enhancement is implemented in WPA3?
Which type of DNS record is used to specify the mail server responsible for accepting email messages on behalf of a recipient's domain?
What is the temporary state that switch ports always enter immediately after the boot process when Rapid PVST+ is used?
Refer to the exhibit.
A network administrator must permit traffic from the 10.10.0.0/24 subnet to the WAN on interlace Seria10. What is the effect of the configuration as the administrator applies the command?
A)
B)
C)
D)
By default, how long will the switch continue to know a workstation MAC address after the workstation stops sending traffic?
SIP-based Call Admission Control must be configured in the Cisco WLC GUI. SIP call-snooping ports are configured. Which two actions must be completed next? (Choose two.)
Which device segregates a network into separate zones that have their own security policies?
What is the functionality of the Cisco DNA Center?
Refer to the exhibit.
A network administrator configures an interface control re switch so that it connects to interface Gi1/0/1 on switch Cat9300-1. Which configuration must be applied to the new interface?
A)
B)
C)
D)
Refer to the exhibit.
The network engineer is configuring a new WLAN and is told to use a static password for authentication instead of the RADIUS servers. Which additional set of tasks must the engineer perform to complete the configuration?
Drag and drop the statements about AAA from the left onto the corresponding AAA services on the right. Not all options are used.
Refer to the exhibit.
What is the subnet mask of the route to the 10.10.13.160 prefix?
Refer to the exhibit. A network administrator is configuring a router for user access via SSH. The service-password encryption command has been issued. The configuration must meet these requirements:
• Create the username as CCUser.
• Create the password as NA!2Scc.
• Encrypt the user password.
What must be configured to meet the requirements?
How does MAC learning function on a switch?
Drag and drop the characteristic from the left onto the IPv6 address type on the right.
Refer to the exhibit.
How many JSON objects are presented?
Refer to the exhibit.
The DHCP server is configured with a DHCP pool for each of the subnets represented. Which command must be configured on switch SW1 to allow DHCP clients on VLAN 10 to receive dynamic IP addresses from the DHCP server?
Which type of address is shared by routers in a HSRP implementation and used by hosts on the subnet as their default gateway address?
Why is TCP desired over UDP for application that require extensive error checking, such as HTTPS?
Refer to the exhibit. How does router R1 handle traffic to the 172.16.1.4/30 subnet?
What is a reason to implement LAG on a Cisco WLC?
A router has two static routes to the same destination network under the same OSPF process. How does the router forward packets to the destination if the next-hop devices are different?
Refer to the exhibit.
How many JSON objects are represented?
Refer to the exhibit.
What is the subnet mask of the route to the 10.10.13.160 prefix?
Drag and drop the TCP or UDP details from the left onto their corresponding protocols on the right.
Refer to the exhibit.
An engineer assigns IP addressing to the current VLAN with three PCs. The configuration must also account for the expansion of 30 additional VLANS using the same Class C subnet for subnetting and host count. Which command set fulfills the request while reserving address space for the expected growth?
A DHCP pool has been created with the name NOCC. The pool is using 192.168.20.0/24 and must use the next to last usable IP address as the default gateway for the DHCP clients. What is the next step in the process?
What is used as a solution for protecting an individual network endpoint from attack?
