Refer to the exhibit. The distribution switches serve as the layer 3 boundary. HSRP preemption is enabled. When the primary switch comes back after a failure, traffic is initially dropped. Which solution must be implemented to improve the design?
Refer to the exhibit. An architect must design a solution to connect bank site A with bank site B and support:
network operation center monitoring end-to-end L3VPN and L2VPN traffic
company adding thousands of routes in the next two years
Which two BGP solutions must the design include? (Choose two.)
Which two considerations must be made regarding the overlay network for a Cisco SD-Access architecture? (Choose two.)
An engineer is designing a networking solution to allow two hosts to communicate—one host located within the company A network and the other within the company B network. The two companies have no other plans for future additional connections. Both companies want to use a single secure and encrypted internet connection, and the configuration must be as simple as possible. Which network solution must the engineer choose?
A customer requires QoS to support multimedia conferencing over MPLS. The network architect chooses to use per-hop behavior. Which solution must the architect use to classify and mark traffic traveling between branch sites?
An organization is designing a detailed QoS plan that limits bandwidth to specific rates. Which two parameters are supported be the traffic policing feature? (Choose two.)
In the SD-WAN underlay network, which WAN Edge VPN ID is defined as the transport VPN and is used to
carry control traffic?
Which NETCONF operation creates filtering that is specific to the session notifications?
The customer solution requires QoS to support streaming multimedia over a WAN. An architect chooses to use Per-Hop Behavior. Which solution should the engineer use to of mark traffic traveling between branch sites?
An engineer is designing a Layer 3 campus network running EIGRP between the core, aggregation, and access layers. The access layer switches will be connected to the aggregation layer using Layer 3 copper connections. The engineer wants to improve convergence time for access layer switch failures. Which technique must the design include?
